604328
95
Zoom out
Zoom in
Previous page
1/111
Next page
Treadmill 200 Series Assembly Guide 10
To attach the cables to the console:
1. Ask your assistant to hold the console over the console bracket while you
carefully route the following console cables:
a. Insert the stop switch cable (1) with the two connector tabs pointing down.
You will feel the cable lock into place.
b. Insert the base unit data cable (2).
c. Once both of these cables are connected, tuck the cables into the left side
of the cable retainer (5), as shown in the figure below.
d. Insert the console ground cable (3) with the round side positioned upward.
e. Insert the touch heart rate cable (4) with the front two tabs pointing down.
f. Once both of these cables are connected, tuck the cables into the right side
of the cable retainer (5).
Important: Make sure that all four cables are tucked into the cable retainer before
you place the console on the bracket. Place excess cable in the console recess where
the cables insert.
Figure 12: Cable guide on back of console
2. Set the console onto the console bracket. It should sit flush on the bracket
without gaps. If there is a gap, check to make sure that no cables are being
pinched between the console and the console bracket.
Note: Do not secure the console to the bracket until instructed to do so.
Figure 13: Console should fit snuggly on console bracket
95


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor TRM 243 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor TRM 243 in the language / languages: English as an attachment in your email.

The manual is 12,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info