604310
49
Zoom out
Zoom in
Previous page
1/58
Next page
QUICKSTART
i
TM
CAUTION: Before using the EFX
®
, read all these instructions.
Failure to do so may result in serious injury.
Do not allow children or those unfamiliar with its
operation, on or near the unit.
Before beginning any fitness program, see your
physician for a thorough physical examination.
See advice from your physician to learn the
target heart rate appropriate for your
fitness level.
Always face the display and use the
stationary handrail for balance. Never
attempt to turn around on the EFX.
If you feel pain, faintness, or
dizziness, stop exercising
immediately.
The Locking Pin on the
Roller Arm
The locking pin on the EFX
ramp secures the roller arm
and prevents it from
continuous travel up or
down the ramp. To prevent
unauthorized use, secure
the roller arm with the locking
pin after every workout.
Pull firmly on the pin to slide
it out of the roller arm. A lanyard
attaches the locking pin to the
ramp. Store the locking pin
underneath the ramp once it
is removed from the roller arm.
Workout Tips
Before and after a workout, gently stretch
your lower body and back to help prevent
stiffness or soreness.
At the beginning of a workout, take several
minutes to bring your heart rate into your
target zone (shown in Diagram D on the
other side of this card).
Depending on your level of fitness, consider
maintaining a pedaling speed between 100
and 150 strides per minute. Do not drop
below 20 strides per minute during a workout
or you enter pause mode.
To pause during your workout, stop pedaling.
Pause mode has a 10-minute limit.
Incorporate a cool-down period into your
workout to help lower your heart rate and
minimize muscle stiffness or soreness.
Begin Your Workout with QUICKSTART
1. Turn ON the EFX, using the I/O power switch at the
base of the rear cover. The Precor banner scrolls
across the center display.
2. Remove the locking pin that secures the roller arm.
3. Hold on to the stationary handrail and step on the
foot pedals.
4. Begin pedaling.
Important: If your unit has moveable handlebars,
do not use them until you are comfortable with the
movement of the EFX.
5. Press QUICKSTART. The Manual (MANL) Program
begins.
Note: To select a different program, refer to your
owner’s manual.
6. Use the RESISTANCE ▲▼ or CROSSRAMP ▲▼
keys to change the resistance and ramp incline
(EFX5.17i and EFX5.21i).
7. Enter a cool-down period by lowering the strides per
minute, the resistance, or the ramp incline.
8. To review your workout summary, press RESET. The
display shows your cumulative time, strides, and the
number of calories burned during your workout.
9. When you are done reviewing your workout summary,
press RESET to return to the banner.
10. Stop pedaling and hold on to the stationary handrail
while you carefully step down from the EFX.
11. To prevent unauthorized use, turn OFF the EFX and
secure the roller arm with the locking pin.
EFX5.17i/5.19/5.21i 48138-103, 06 September 2005, en
C
M
Y
CM
MY
CY
CMY
K
EFX_Quickstart Card_front_5.17i_5.19_5.21i.pdf 8/29/2005 12:52:32 PMEFX_Quickstart Card_front_5.17i_5.19_5.21i.pdf 8/29/2005 12:52:32 PM
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor EFX 5.21I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor EFX 5.21I in the language / languages: English as an attachment in your email.

The manual is 4,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info