604307
90
Zoom out
Zoom in
Previous page
1/111
Next page
Assembling the Equipment
9
To attach the lower link arms to the movable arms:
1. Attach the right lower link arm to the movable arm using one joint connector
screw, one star washer, and one joint connector nut. Fully tighten the
fasteners using the 5 mm hex wrench.
CAUTION: Guide the handlebar to its balance point and let it rest there. When
attaching the lower link arms, have your assistant hold the moving handlebar.
Failure to do so could result in injury.
Figure 12: Lower link arm attachment
2. Repeat this procedure to attach the left lower link arm to the left movable arm.
Attaching the Stabilizer (EFX 423 Model Only)
This assembly procedure applies to EFX 423 model only. For other models, the
stabilizers will be attached at a later point in the assembly.
To attach the stabilizers:
1. Slide the handlebar shaft into the stabilizer assembly as shown in the
following figure and secure it using two ¹₄-inch x ₈-inch buttonhead screws.
Fully tighten the fasteners.
Figure 13: Secure the handlebar shaft
2. Insert a clamp into each stabilizer and secure it loosely with two buttonhead
screws.
Figure 14: Location of clamp in stabilizer
90


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor EFX 447 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor EFX 447 in the language / languages: English as an attachment in your email.

The manual is 14,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info