Manual Precor 954I Treadmill (page 89 of 96) (English)

604349

Zoom out

Zoom in

1/96

532i Elliptical Fitness CrossTrainer Assembly Guide 7

Prepare the stabilizers for installation. Use a ⁵₃₂-inch hex key

to loosen the two clamp fasteners.

Thread a leveler (L) onto each stabilizer.

Note: Make sure the nut is fully threaded onto the leveler.

Refer to the illustration.

For easier access to the base mounts, lift the front of the EFX

off the floor and place a wedge of packaging beneath its

base.

Install the stabilizer with the cable protruding from both ends.

This requires coordinating efforts. Read through the following

two steps before proceeding.

1. Ask your assistant to connect the base cable while you

hold the stabilizer close to the frame. An audible click is

heard when the cable is properly attached. Place any

excess cable inside the base frame.

2. While the cable is being attached, you need to place the

stabilizer onto the metal shaft and engage the clamp.

Wrench tighten the two fasteners in the clamp. Rotate and

slide the shaft cover so the tabs rest on the heads of the

two fasteners. Apply pressure to secure the shaft cover in

place.

Secure the stabilizer to the base frame using four hex head

screws (A), four split washers (E) and four washers (B).

Finger tighten.

Note: The split washers should be sandwiched between the

head of the screw and the flat washers. Also, if you encounter

difficulty aligning the base mounts, check the height of the

levelers and adjust them accordingly.

Attach the opposite stabilizer to the metal shaft and wrench

tighten the clamp. Rotate the shaft cover so the tabs rest on

the heads of the two fasteners. Apply pressure to secure the

shaft cover in place. Secure the stabilizer to the base frame

using four hex head screws (A), four split washers (E), and

four washers (B). Finger tighten.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Precor 954I Treadmill in the language / languages: English as an attachment in your email.

The manual is 9,48 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Precor 954I Treadmill Manual

Product: