604348

Precor 932i Treadmills Manual

34
Zoom out
Zoom in
Previous page
1/96
Next page
Treadmill: Checking the Alignment of
the Running Belt
Proper belt alignment allows the belt to remain centered and
ensures smooth operation. Realigning the belt takes a few simple
adjustments. If you are unsure about this procedure, call Precor
Customer Support. Refer to Obtaining Service.
CAUTION: Special care must be taken when aligning the running
belt. Turn Off the treadmill while adjusting or working near the
rear roller. Remove any loose clothing and tie back your hair. Be
very careful to keep your fingers and any other object clear of the
belt and rollers, especially in front of the roller and behind the
deck. The treadmill will not stop immediately if an object
becomes caught in the belt or rollers.
1.
2.
3.
4.
5.
6.
7.
8.
Make sure that the running surface is level. To operate correctly,
the treadmill needs to be as level as possible. If needed, the rear
feet can be adjusted to level the treadmill (refer to the Assembly
Guide).
Turn the equipment On.
Stand beside the treadmill and press QUICKSTART.
If needed, enter the safety code by pressing the number keys in
sequence: 1, 2, 3, 4.
The running belt starts automatically after a 3-second
countdown appears on the display.
Press the SPEED up key until the display shows a speed of
3 mph (5 kph).
CAUTION: If you hear any chafing or the running belt appears
to be getting damaged, stop the running belt immediately by
pressing the red STOP button. Contact Precor Customer
Support.
Walk around to the rear of the equipment and observe the belt
for a few minutes. The belt should run centered along the
running bed. If the belt drifts off center, you must make
adjustments. Refer to Treadmill: Adjusting the Running Belt.
Important: Failure to align the belt may cause the belt to tear or
fray, which is not covered by the Precor Limited Warranty.
To stop the running belt, press the red STOP button.
Turn the treadmill Off.
Product Owner's Manual: Maintenance 32
… 34 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor 932i Treadmills at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor 932i Treadmills in the language / languages: English as an attachment in your email.

The manual is 9,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info