9.3x Low-Impact Treadmills Assembly Guide 1
Thank you for choosing Precor. For proper installation, please read this guide
thoroughly and follow the assembly instructions. If you do not assemble the
treadmill according to these guidelines, you could void the Precor Limited
Warranty.
Obtaining Service
You should not attempt to service the treadmill except for minor belt adjustments
and maintenance as described in the owner’s manual. Should you need more
information regarding customer support numbers or a list of Precor authorized
service centers, visit the Precor website at www.precor.com/cons.
Unpacking the Equipment
The treadmill is carefully tested and inspected before shipment. The unit is shipped
in one box. Ask for help from two or more people to unpack and assemble the
treadmill. If any items are missing, contact your dealer.
Required Tools
• Phillips-head screwdriver
• Crescent wrench
• Bubble level
• Wire cutter
Installation Requirements
Follow these installation requirements when assembling the unit:
• Assemble the unit near the location where you plan to use it.
• Provide ample space around the unit.
Open space around the unit allows for easier access.
• Set up the unit on a solid, flat surface.
A smooth, flat surface under the unit helps keep it level. A level unit has fewer
malfunctions.
• Open the box and assemble the components in the sequence presented
in this guide.
• Obtain assistance.
Ask another capable adult for assistance during the assembly process.
• Use your fingers or the appropriate tools to insert fasteners.
Proper alignment helps alleviate crossthreading. Do not fully wrench tighten
fasteners until instructed to do so.
Important: When wrench tightening, the head of the fastener should be flush
with the product. If it is not, cross-threading has occurred. Do not attempt to
rework the assembly as more damage to the unit will occur. Contact
Customer Support. Refer to Obtaining Service.
• If you plan to move the unit, obtain help and use proper lifting techniques.
Grasp the one-piece plastic end cap to lift the treadmill and roll it on its front
wheels. Do not grasp any other plastic part while lifting or moving the unit. The
other plastic pasts are not reinforced and they may break.
