604352
89
Zoom out
Zoom in
Previous page
1/96
Next page
532i Elliptical Fitness CrossTrainer Assembly Guide 7
Prepare the stabilizers for installation. Use a ⁵₃₂-inch hex key
to loosen the two clamp fasteners.
Thread a leveler (L) onto each stabilizer.
Note: Make sure the nut is fully threaded onto the leveler.
Refer to the illustration.
For easier access to the base mounts, lift the front of the EFX
off the floor and place a wedge of packaging beneath its
base.
Install the stabilizer with the cable protruding from both ends.
This requires coordinating efforts. Read through the following
two steps before proceeding.
1. Ask your assistant to connect the base cable while you
hold the stabilizer close to the frame. An audible click is
heard when the cable is properly attached. Place any
excess cable inside the base frame.
2. While the cable is being attached, you need to place the
stabilizer onto the metal shaft and engage the clamp.
Wrench tighten the two fasteners in the clamp. Rotate and
slide the shaft cover so the tabs rest on the heads of the
two fasteners. Apply pressure to secure the shaft cover in
place.
Secure the stabilizer to the base frame using four hex head
screws (A), four split washers (E) and four washers (B).
Finger tighten.
Note: The split washers should be sandwiched between the
head of the screw and the flat washers. Also, if you encounter
difficulty aligning the base mounts, check the height of the
levelers and adjust them accordingly.
Attach the opposite stabilizer to the metal shaft and wrench
tighten the clamp. Rotate the shaft cover so the tabs rest on
the heads of the two fasteners. Apply pressure to secure the
shaft cover in place. Secure the stabilizer to the base frame
using four hex head screws (A), four split washers (E), and
four washers (B). Finger tighten.
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor 842 Cycle at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor 842 Cycle in the language / languages: English as an attachment in your email.

The manual is 9,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info