604363
95
Zoom out
Zoom in
Previous page
1/101
Next page
EFX546i Elliptical Fitness Crosstrainer Assembly Guide 5
Rear
view of
console
Attach both upright supports to the base frame using eight
buttonhead screws (A), eight split washers (C), and eight
washers (B). Finger tighten.
Ask your assistant to hold the display console above the upright
supports while you connect the cable. Remove and discard the tape
after you connect the cable.
Important: Place excess cable inside the upright support.
Have your assistant lower the display console while you align the
mounting brackets on the inside of the upright supports.
Fasten the display console to each upright support by threading a
buttonhead screw (A), washer (B), and split washer (C) through
opposite mounting holes. Check that the base fasteners are loose
before installing the display console fasteners.
CAUTION: Make sure the display console screws are properly
threaded into the inserts. Do not cross thread. The Precor
Limited Warranty does not cover damage that occurs during
installation.
C
heck alignments and thread the remaining four display console
screws (A), four washers (B), and four split washers (C). Wrench
tighten with a ³⁄₁₆-inch hex key so the assemblies come together, but
leave room for adjustments.
When all fasteners are snug against the unit, begin at the base and
alternately wrench tighten all fasteners. Follow the sequence from
step 4 through step 8.
95


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor 776I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor 776I in the language / languages: English as an attachment in your email.

The manual is 5,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info