534698
11
Zoom out
Zoom in
Previous page
1/54
Next page
3. Operation
UP! 3D Printer User Manual 10
Platform: Raise the platform axis to a height at which you can reach under it
to insert the screws. Line up the screw holes (e, f) on the platform with the
screw holes on the heater base and insert the screws in from the bottom and
tighten them.
Perfboard: Fix the perfboard on the platform with 4 clips at each corner. (see
3.3.5)
Roller shaft: Unscrew the screw (b) from the printer, and then fix the roller shaft
with the screw. Please note that the roller shaft should lock into the screw (a).
Material Extrude (top view)
(1) Connect the power adapter to the power interface.
(2) Insert the end of ABS filament into the Filament tube.
(3) Start the UP! Software (refer to the software install procedure in 3.1.2 if you
have not already installed it), and press the ―Extrude‖ button in the
―maintenance‖ dialogue box, which is accessed from the ―3D Print‖ menu.
(4) After the printer nozzle has warmed up to 26C, the printer will beep. Push
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PP3DP Up Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PP3DP Up Plus in the language / languages: English as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info