685351
11
Zoom out
Zoom in
Previous page
1/204
Next page
OPERATING THE ENGINE
NON-ECU CONTROLLED
5
ENGINE STARTING CONTROLS
1. Main Switch: Turns power On or Off to
the engine start circuit.
2. ON Position: Must be in this position
for the engine to start and run.
3. OFF Position: Used to cut the power to
the start circuit of the engine. Always
turn the switch to the OFF position
when servicing the generator set or
engine.
4. Start: Position to use for starting the
engine. The switch will return to the
original position when released.
5. Stop: Position used to stop the engine.
The switch will return to the original
position when released.
6. Preheat / Prime: Preheats combustion
chamber before starting. Primes fuel
system.
STARTING THE ENGINE
1. Before starting the engine, be sure to
disconnect the power supply from power
line. The engine may be hard to start if a
load is connected.
2. Press the Start / Stop switch to the
“Stop” position for six (6) seconds. This
will preheat the combustion chambers
and aid in starting.
3. Press the Start / Stop switch to the
“Start” position. This will engage the
starter motor and start the engine.
4. Release the Start / Stop switch when the
engine starts.
CHECK ENGINE AFTER STARTING
1. Allow the engine to warm up 3 to 5
minutes before applying a load. In
colder climates allow a few extra
minutes longer.
2. Check all areas of engine and generator
during warm up. Visual inspection.
3. Listen for abnormal noises.
4. Check for abnormal exhaust gas.
STOPPING THE ENGINE
First, disconnect the power load. Next
press the Start / Stop switch to the Stop
position, the engine will shut down.
NOTE:
Failure to follow this procedure may harm
the generator and cause a premature
malfunction.
IMPORTANT:
If the engine fails to start on the first attempt, wait approximately 30 seconds than follow the starting
procedure again. Do not run the starter for more than 30 seconds per starting attempt. Allow the starter
to cool 2 minutes between subsequent starting attempts.
IMPORTANT:
Damage to the Starter Motor, Starter Solenoid, Run Solenoid or any generator component due to
excessive or prolonged starting attempts attributed to an external Low Battery Control Monitoring or
Auto-Start System will not be covered by the Power Technology Southeast, Inc. Limited Warranty.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PowerTech PTS-50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PowerTech PTS-50 in the language / languages: English as an attachment in your email.

The manual is 14,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info