685353
52
Zoom out
Zoom in
Previous page
1/66
Next page
TROUBLESHOOTING
Trouble Possible Cause Suggested Action
Power leads to unit are
reversed.
Confirm correct wiring for ground
And bat, and re-attempt testing.
Unit does not operate when powered to test
mode
Bad ground connection from
engine to controller unit.
Run wire directly from battery – to the
ground terminal #6 on controller unit.
Battery is low or terminals are
dirty.
Clean terminals and re-charge battery.
Replace battery if necessary.
Crank circuitry wiring
improperly connected.
Refer to engine control wiring and check
crank connections.
Bad ground connection from
engine to controller.
Run wire directly from battery – to the
ground terminal #6 on controller unit.
Engine doe not crank
Crank relay damaged. Or on
board fuse is blown.
Check wiring, on board 10A fuse and relay.
Replace fuse, relay and re-test controller
again.
Out of fuel. Check fuel level, add fuel if necessary.
Ignition control wiring not
installed properly
Refer to engine control wiring and check
ignition connections.
Engine cranks but doesn’t start
Fuel relay damaged Check fuel relay and replace if damaged.
Engine starts but shuts down after “Oil
Bypass period” due to low oil / high temp /
extra.
Oil / temp. / extra input wiring
improperly connected.
Check wiring for proper connections.
Engine starts, but running LED does not
illuminate.
Fault (short or overload) on
one of the annunciated outputs.
Check for fault, once fault is corrected then
operation resumes.
Annunciation output not working Fault (short or overload) on
one of the annunciated outputs.
Check for fault, once fault is corrected then
operation resumes.
Preheat LED works OK but timer output
does not activate
Fault (short or overload) on
timer output.
Check for fault, once fault is corrected then
operation resumes.
17
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PowerTech PTS-17.5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PowerTech PTS-17.5 in the language / languages: English as an attachment in your email.

The manual is 3,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info