POWXG90425 EN
Copyright © 2018 VARO P a g e | 7 www.varo.com
4. Lock the trigger gun. (Fig. 5)
When releasing the trigger of the trigger gun, the machine automatically stops. The machine
will start again when you re- activate the trigger gun.
6.6 Adjustable nozzle (Fig. 6)
The pressure can for the adjustable nozzle be adjusted by tuning it.
WARNING: Do not do this under operation to avoid that the hand hits the
jet.
6.7 Rotate The Gun (Fig. 7)
The gun rotating will adjust your cleaning angle during a full fan spray pattern , to make every
user find its most comfortable and efficient cleaning position. Push the button to “unlock” side,
the rotating function will be opened. And push the button to “unlock” side if you don’t need
this function .
6.8 Patio Cleaner
The patio cleaner is a powerful accessory for cleaning patio, driveways, etc.
Attach the Patio Cleaner to the lance.
NOTE: Do not use the Patio Cleaner as a broom but let is surf smoothly over the surface
6.9 Detergent dispenser (Fig 8 & 9)
The pressure cleaner will dispense detergent at low pressure. Use the
adjustable spray nozzle to rinse clean.
The built-in detergent dispenser will allow you to apply many forms of liquid detergent onto the
work surface. Detergent application happens at low-pressure only. Insert the adjustable nozzle
onto the gun, and turn it to end of “∆” , so that the pressure washer is in low-pressure mode
(Fig. 8). Remove the cap on the detergent reservoir and fill with liquid detergent only (Fig. 9).
Do not put any water into the reservoir. The pressure washer will mix water and detergent
automatically. When finished applying the detergent to the work surface, turn it to end of “ I” of
the adjustable nozzle and spray off the detergent by using the high-pressure spray (Fig 8). In
high-pressure mode, the pressure washer will not dispense detergent.
6.10 Detergent rate (Fig 10)
If you need to adjust the detergent rate, you can turn the know to the left end for bringing down
it and turn the knob to the right end for raising it. That depend on your special cleaning
demand.
6.11 Pipe cleaning set
▪ Disconnect the electrical plug from the socket.
▪ Shut off the water supply and activate the trigger gun to relieve the machine of pressure.
▪ Remove the lance from the gun.
▪ Attach the special connector for pipe cleaning set to the gun.
▪ Connect the pipe cleaning set to the special connector.
7 TECHNICAL DATA
