672537
8
Zoom out
Zoom in
Previous page
1/13
Next page
POWXG9009 EN
Copyright © 2018 VARO NV P a g e | 8 www.varo.com
Do not run the pump without connecting to the water supply and turning
the water on. Such failure can damage the pressure washer.
10.5 Connect the high-pressure hose to the delivery pipe outlet (Fig .10)
Attach the end of the high pressure hose to the high pressure outlet.
Turn on the water supply and squeeze the gun trigger until the water flows in a steady
stream through the lance. Do not use water which exceeds 60 °C.
11 OPERATING INSTRUCTIONS
11.1 Pressure washer location
Locate the pressure washer on a solid and level surface so that the engine and pump
crankcase oil lubricate components properly. Avoid areas where puddles are pounded.
Slippery surfaces can cause injuries.
Locate the machine in a well-ventilated area and away from flammable materials or fumes.
Be sure ventilation warnings are observed. Keep pressure washer at least 18”away from
flammable materials.
Locate the machine in a way, that the operator has easy access to the pressure washer
and its controls. Locate the machine so that it is protected from external damage.
To prevent damage and excessive hose wear; locate the pressure washer so that the
hose does not cross traffic areas.
11.2 Start-up procedure (Fig. 11 &12)
Place pressure washer on a level surface.
Turn on the water
Purge the system’s pump of air by releasing the safety and squeezing the trigger of the
spray gun.
Attach the lance to the spray gun.
Turn fuel valve to the ‘ON’ position.
Slide the choke lever to the ‘CHOKE’ position
Turn the engine OFF/ON switch to the ‘ON’ position.
Holding the machine with your hand, pull the recoil handle (starter cord) slowly until
resistance is felt, then pull rapidly. Squeeze the trigger gun and release the pressure after
every failed attempt to start the pressure washer (this will reduce the back pressure)
Let engine run for several seconds and then gradually slide the choke lever to the RUN
position as the engine warms up until the choke is fully slid to the RUN position.
11.3 Stopping pressure washer (Fig. 13)
Turn the on/off switch to the OFF position.
Turn the fuel valve to the OFF position.
Turn off the water and squeeze the trigger handle to release all water pressure.
11.4 Adjusting the spray pattern (Fig. 14)
Warning: Always ensure that the wand is fixed correctly. Otherwise it could be injected under
high pressure when operating the gun, possibly causing injury or damage.
11.4.1 nozzle (coloured red)
This nozzle delivers a pinpoint stream and is extremely powerful. It covers a very small area of
cleaning. This nozzle should only be used on surface that can withstand this high pressure
such as metal or concrete. Do not use on wood.
8


Need help? Post your question in this forum.

Forumrules
1

Forum

powerplus-powxg9009

Reset search

  • I am trying to fit the red oil plug do I remove the plastic nut, as I have been trying to remove the black plastic nut with a spanner but it is becoming rounded. Submitted on 3-9-2021 at 17:10

    Reply Report abuse
  • Hi there I just purchased Power plus power washer, I filled it with engine oil 15w-40 and petroleum. I’m not sure if I have to put oil in the pump would you be able to tell me. Thanks. Submitted on 30-8-2021 at 19:11

    Reply Report abuse
  • Where can I buy a replacement air filter. I bought the pressure washer I Lidl Submitted on 17-5-2020 at 13:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWXG9009 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXG9009 in the language / languages: English as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXG9009

Powerplus POWXG9009 User Manual - German - 15 pages

Powerplus POWXG9009 User Manual - Dutch - 15 pages

Powerplus POWXG9009 User Manual - French - 15 pages

Powerplus POWXG9009 Additional guide - All languages - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info