POWXG7201 EN
Copyright © 2020 VARO P a g e | 10 www.varo.com
To remove the complete tines from the shaft:
▪ Remove the lock pin from the end of the shaft.
▪ Take off the outer tine set from shaft.
▪ Remove the lock pin and take off the inner tine set from tine shaft.
▪ Reverse above steps to install tines.
11.4 Change tines from bracket
When one or two pieces of tine broken, it is necessary to change the damaged tine instead of
complete tine set.
▪ Loosen the screws from one side while hold the lock nuts from other side.
▪ Take off the damaged tine and replace with the new one.
11.5 Checking transmission lubricant (Fig. 7)
Drain screw plug is located on the right side of transmission housing.
▪ Lay the tiller on its left side and clean the transmission to prevent dirt and debris before
remove the drain screw.
▪ Using a hex key 5 mm to unscrew the plug and empty the oil from the transmission.
▪ If necessary, disassemble tines.
▪ Reinstall the drain screw plug.
12 STORAGE
The tiller should be stored in a dry and clean room and out of reach of children.
During extended periods of storage, during the winter for example, ensure that the application
is protected against corrosion and frost.
At the end of the season, or if the application is not to be used for longer than a month:
▪ Clean the application.
▪ Wipe over all metal surfaces with an oil-impregnated cloth to protect them from corrosion
(non-resinous oil), or spray a fine coat of oil onto them from a can.
▪ Fold the guide bar down, and store it in a suitable place.
13 TROUBLE SHOOTING
