POWXG7201 EN
Copyright © 2020 VARO P a g e | 7 www.varo.com
▪ The use of a safety circuit-breaker is recommended for the power supply line for an
intervention range of 10 to 30 rated mA. Consult a reliable electrician.
▪ Never pass the appliance over the extension cable that the application is working, as this
could cut the cable. Mark sure you always know where the cable is.
▪ Use the special cable holder for the connection of the extension cable.
▪ Never use the appliance when it is raining. Try to prevent it from getting wet or being
exposed to humidity. Do not leave it outside overnight. Do not cut damp or wet grass.
▪ The power supply cable should be checked regularly and before using it each time, make
sure the cable is not damaged or old out. If the cable is not in good condition, do not use
the appliance; take it to an authorized service centre instead.
▪ Only use an extension cable that is suitable for outdoor work. Keep it away from the
cutting area, from damp, wet or oily surfaces or with sharp edges and away from heat and
fuels.
▪ The mobile socket of the extension cable should be splash proof in compliance with DIN
57282 and VDE 0282 regulations; the cross-section of the wire (max. length 75 m) should
be at least 1.5 mm². Use H07RN-F harmonized cable.
7 GUIDELINES FOR USING EXTENSION CORDS
▪ Make sure the extension cord is in good condition. When using an extension cord, be sure
to use one that is heavy enough to carry the current that your product will draw. An
undersized cord will cause a drop in line voltage, which will result in loss of power and
overheating.
▪ Make sure your extension cord is properly wired and in good condition. Always replace a
damaged extension cord, or have it repaired by a qualified person before using it. Protect
your extension cords from sharp objects, excessive heat, and damp or wet areas.
▪ Before connecting the motor to the power line, make sure the switch is in the OFF position
and the electric current is rated the same as the current stamped on the motor nameplate.
Running at a lower voltage will damage the motor.
This tool must be grounded while in use in order to protect the operator
from electric shock.
8 ASSEMBLY
8.1 Attaching the carrying handle
▪ Insert the carrying handle (1) to bar lower section (2) and fix it by two supplied screws and
nuts.
8.2 Upper guide bar (Fig. 2)
▪ Slide the cable relief onto the upper guide bar.
▪ Connect guide bar by inserting both side the supplied bolts and swing nut.
▪ You can also assemble the guide bar to the bottom holes to adjust the height.
▪ Using supplied two cable clips to hold cable.
