POWXG60250 EN
Copyright © 2020 VARO P a g e | 9 www.varo.com
8 ASSEMBLY
8.1 Folding handle (Fig. 1)
▪ Attach the lower part of the handle section to the body of the machine, using the nuts and
bolts.
▪ The nuts must always point to the outside of the machine.
▪ The upper handles come pre-mounted to the lower part of the handle section.
IMPORTANT: Unfold handle carefully so as not to pinch or damage control cables.
▪ Raise handles until lower handle section locks into place in mowing position. Tighten all
bolts.
▪ Remove protective padding, raise upper handle section into place on lower handle and
tighten both handle knobs.
Caution: Traction and starter cables must always be positioned on top of
the cross bar of the push handle. This provides free movement of the
cables on top of the lower section of the push handle, when the handle is
folded. Incorrect mounting of these cables could lead to damaging and/or
straining them, resulting in a malfunction of the machine. In this case the
guaranty is void.
8.2 Starter handle (Fig. 2)
Move the starter handle from the engine to the rope guide.
9 OPERATION
9.1 Before starting
This lawn mower is shipped WITHOUT OIL OR GASOLINE in the engine
9.1.1 Add oil
Before each subsequent use the oil level must be check and if necessary topped up with 5
600ml SAE30 engine oil.
CAUTION: DO NOT overfill engine with oil, or it will smoke heavily from the
muffler on startup.
▪ Be sure lawnmower is level.
▪ Remove oil dipstick from oil fill spout.
▪ Wipe the oil dipstick clean; refit and tighten teh oil tank cap and then remove it again. The
oil level must be within the marking and should be clear with gold colour.
▪ Refill if the oil level is too low.
IMPORTANT:
▪ Check oil level before each use. Add oil if needed. Fill to full line on dipstick.
▪ Change the oil after every 25 hours of operation or each season. You may need to change
the oil more often under dusty, dirty conditions.
