672470
13
Zoom out
Zoom in
Previous page
1/15
Next page
POWXG3042 EN
Copyright © 2017 VARO P a g e | 13 www.varo.com
14 STORAGE
WARNING: Failure to follow these steps may cause varnish to form in the
carburettor and lead to difficult starting or permanent damage after storage.
Clean outside surface of unit.
Drain fuel from the fuel tank.
After fuel is drained, start engine.
Run engine at idle until unit stops. This will purge the carburettor of fuel.
Allow engine to cool (approx. 5 minutes).
Using a sparking plug wrench, remove the sparking plug.
Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace sparking plug.
Store unit in a cool, dry place away from any source of ignition such as an oil burner,
water heater, etc.
Put the sleeve on when not in use or in transportation.
15 REMOVING A UNIT FROM STORAGE
Remove sparking plug.
Pull starter rope briskly to clear excess oil from combustion chamber.
Clean and gap sparking plug or install a new sparking plug with proper gap.
Prepare unit for operation.
Fill fuel tank with proper fuel / oil mixture. See Fuel and Lubrication Section.
16 TROUBLE SHOOTING
PROBLEM
PROBABLE CAUSE
CORRECTIVE ACTION
Unit won’t start or
starts but will not run.
Incorrect starting
procedures.
Incorrect carburettor
mixture adjustment
setting.
Fouled sparking plug.
Empty fuel tank.
Primer bulb was not
pressed enough.
Follow instructions in the User
Manual.
Have carburettor adjusted by
an Authorized Service Centre.
Clean/gap or replace plug.
Fill fuel tank with properly
mixed fuel.
Press primer bulb fully and
slowly 10 times.
Unit starts, but
engine has low
power.
Fuel filter is plugged.
Incorrect lever position.
Dirty spark arrester
screen.
Dirty air filter.
Incorrect carburettor
mixture adjustment
setting service dealer.
Replace the fuel filter.
Move to RUN position.
Replace spark arrester screen.
Remove, clean and reinstall
filter.
Have carburettor adjusted by
an Authorized Service Centre.
Engine sputters.
Incorrect carburettor
mixture adjustment
setting.
Air filter is blocked.
Old or improperly mixed
fuel.
Have carburettor adjusted by
an Authorized Service Centre.
Replace or clean the air filter.
Drain gas tank/add fresh fuel
mixture.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWXG3042 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXG3042 in the language / languages: English as an attachment in your email.

The manual is 0,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXG3042

Powerplus POWXG3042 User Manual - German - 18 pages

Powerplus POWXG3042 User Manual - Dutch - 17 pages

Powerplus POWXG3042 User Manual - French - 17 pages

Powerplus POWXG3042 Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info