POWXG30410 EN
Copyright © 2020 VARO P a g e | 7 www.varo.com
▪ DO NOT USE ANY OTHER CUTTING ATTACHMENT. Only use our replacement parts
and accessories, which are designed specifically to enhance the performance and
maximize the safe operation of our products. Failure to do so may cause poor
performance and possible injury. Use only the stringhead supplied with this product. Do
not use any other cutting attachment. Use of such attachments will void your factory
warranty and may result in serious bodily injury.
8 ASSEMBLY
Switch off the tool and remove the cap from the spark plug before fulfilling all
procedures.
Do not draw up the fastening elements too tight to avoid damaging the thread.
8.1 Bike handle installation (Fig. 1)
▪ Install the U-handle on the fixing holder, install the clamp and fasten with the screws.
▪ To adjust the angle of the additional handle, loosen the 4 upper bolts and change the
angle of inclination. After finishing the adjustment, tighten the bolts.
8.2 Installation protection guard (Fig. 2)
▪ Position the guard so it can be fixed into place with the clamp and the screws.
▪ Tighten the screws.
8.3 Installing the harness (Fig. 3)
▪ Put on the carrying belt.
▪ Adjust the length of the belt in such a way that you feel comfortable and suspend the tool
on the safety catch of the carrying belt.
▪ The cutting accessory should touch the ground. If this is not the case, make adjustment.
▪ Loosen the clamping bolt with the Allen key.
▪ Move the fastening to the desired position by sliding it along the tube.
▪ Tighten the clamping bolt with the Allen key.
8.4 Installing the cutting disc/spool
CAUTION: NEVER use unit if blade is warped or has teeth that are chipped or
missing. Replace a damaged blade immediately.
CAUTION: Always wear heavy-duty work gloves when handling and installing
a blade.
8.4.1 Assembly metal blade (Fig. 4)
▪ Set the inner holder to the gear shaft and turn to fix with the attached L-shaped bar.
▪ Put the blade on the inner holder with letters to the gear case and match correctly the hole
of the blade to the projection of the inner holder.
▪ Set the outer holder to the gear shaft with the hollowed face to the blade.
▪ Put the attached bolt cover on the outer holder and secure it with the bole (left screw)
together with the spring washer and the washer.
1. NUT
2. Spring washer
3. Washer
4. Outer holder
5. Blade
6. Gear shaft
7. Bar
8. Inner holder
9. Gear case
