714930
18
Zoom out
Zoom in
Previous page
1/25
Next page
POWXG1022 EN
Copyright © 2016 VARO P a g e | 18 www.varo.com
11.5 Spark arrester screen
Note: a clogged spark arrester screen will dramatically reduce engine
performance.
Remove the 2 bolts (A) and pull muffler out (Fig. 17a).
Remove the 2 screws that holds the cover (B) (Fig. 17b).
Discard the used spark arrester screen (D) and replace it with a new one.
Reassemble the muffler components and install the muffler to the cylinder. Tighten
securely.
11.6 Spark plug
Note: for efficient operation of saw engine, spark plug must be kept clean
and properly gapped.
Push stop switch down.
Remove knob (A) holding air filter cover in place, remove the top cover (B) by loosening
the cover retaining screw. Cover will lift off (Fig. 18a).
Disconnect the wire connector (C) from the spark plug (D) by pulling and twisting at the
same time (Fig. 18b).
Remove spark plug with spark plug socket wrench.
DO NOT USE ANY OTHER TOOL
Check electrode gaps with wire feeler gauge and set gaps to .025” (.635mm) if necessary.
Reinstall a new spark plug.
Note: a resistor spark plug must be used for replacement.
Note: this spark ignition system meets all requirements of the interference-
causing equipment regulations.
11.7 Carburetor adjustment
The carburetor was pre-set at the factory for optimum performance.
If further adjustments are necessary, please take your unit to the nearest qualified service
technician.
12 MAINTENANCE
12.1 Guide bar maintenance
Frequent lubrication of the guide bar (railed bar which supports and carries the saw chain)
sprocket tip is required. Proper maintenance of the guide bar, as explained in this section, is
essential to keep your saw in good working condition.
1. Dismount the Saw Chain (1) and Guide Bar (2) by following the instructions in
‘Assembling the chainsaw’ in reverse
2. Remove saw dust from the bar groove and oiling port using a small screwdriver, probe
(not included) (see Fig. 19), or compressed air
3. Inspect the Guide Bar and the sprocket on its tip. Lubricate the sprocket with a suitable
maintenance spray
4. Deburr, turn over or replace the Guide Bar as required
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWXG1022 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXG1022 in the language / languages: English as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXG1022

Powerplus POWXG1022 User Manual - German - 29 pages

Powerplus POWXG1022 User Manual - Dutch - 26 pages

Powerplus POWXG1022 User Manual - French - 28 pages

Powerplus POWXG1022 User Manual - Italian - 27 pages

Powerplus POWXG1022 User Manual - Spanish - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info