POWXG10211 EN
Copyright © 2020 VARO P a g e | 4 www.varo.com
CHAINSAW 37.2 CC – 400MM
POWXG10211
1 INTENDED USE
These models are intended for infrequent use by homeowners, cottagers, and campers, and
for such general applications as clearing, pruning, cutting firewood, etc. They are not intended
for prolonged use. If the intended use involves prolonged periods of operation, this may cause
circulatory problems in the user’s hands due to vibration. Not suitable for professional use.
WARNING! Read this manual and general safety instructions carefully
before using the appliance, for your own safety. Your power tool should
only be passed on together with these instructions.
Only use Bio-degradable oil (environment-friendly) to lubricate the chain.
Note: Observe all applicable federal, state and local safety regulations
standards and ordinances. National regulation may restrict the use of this
machine.
2 DESCRIPTION (FIG. 1)
1. Saw chain
2. Guide bar
3. Spark arrester screen
4. Chain brake lever / hand guard
5. Front handle
6. Starter handle
7. Engine switch
8. Safety trigger
9. Rear handle / boot loop
10. Oil tank cap
11. Fuel tank cap
12. Starter cover
13. Spiked bumper
14. Bar retaining nuts
15. Muffler shield
16. Air cleaner cover
17. Choke lever
18. Saw chain adjustment screw
19. Chain catcher
20. Throttle/ trigger
LOW KICKBACK SAW CHAIN helps significantly reduce kickback, or the intensity of
kickback, due to specially designed depth gauges and guard links.
CHAIN BRAKE is a safety feature designed to reduce the possibility of injury due to kickback
by stopping a moving saw chain in milliseconds. It is activated by the Chain Brake lever.
SPARK ARRESTER SCREEN retains carbon and other flammable particles over 0.023
inches (0.6 mm) in size from engine exhaust flow. Compliance with local, state and federal
laws and/or regulations governing the use of a spark arrester screen is the user’s
responsibility. See Safety Precautions for additional information.
ENGINE SWITCH immediately stops the engine when tripped. Engine switch must be pushed
to ON position to start or restart engine.
