Manual Powerplus POWXG1018 (page 13 of 22) (English)

517143

Zoom out

Zoom in

1/22

POWXG1018 EN

WARNING: Never walk in front of a tree that has been notched. Make the

felling cut (D) from the other side of the tree and 1.5 - 2.0 inches (3-5 cm)

above the edge of the notch (C) (Fig. 11b)

Never saw completely through the trunk. Always leave a hinge. The hinge guides the tree. If

the trunk is completely cut through, control over the felling direction is lost.

Insert a wedge or felling lever in the cut well before the tree becomes unstable and starts to

move. This will prevent the guide bar from binding in the felling cut if you have misjudged the

falling direction. Make sure no bystanders have entered the range of the falling tree before you

push it over.

Warning: before making the final cut, always recheck the area for

bystanders, animals or obstacles.

Felling cut:

 Use wooden or plastic wedges (A) to prevent binding the bar or chain (B) in the cut.

Wedges also control felling (fig. 11c)

 When diameter of wood being cut is greater than the bar length, make 2 cuts as shown

(fig. 11d).

WARNING: As the felling cut gets close to the hinge, the tree should begin

to fall. When tree begins to fall, remove saw from cut, stop engine, put

chain saw down, and leave area along retreat path (Fig. 11a).

10.8.2 Limbing

Limbing a tree is the process of removing the branches from a fallen tree. Do not remove

supporting limbs until after the log is bucked (cut) into lengths (Fig. 12).

Branches under tension should be cut from the bottom up to avoid binding the chain saw.

WARNING: Never cut tree limbs while standing on tree trunk.

10.8.3 Bucking

Bucking is cutting a fallen log into lengths. Make sure you have a good footing and stand uphill

of the log when cutting on sloping ground. If possible, the log should be supported so that the

end to be cut off is not resting on the ground. If the log is supported at both ends and you must

cut in the middle, make a downward cut halfway through the log and then make the undercut.

This will prevent the log from pinching the bar and chain. Be careful that the chain does not cut

into the ground when bucking as this causes rapid dulling of the chain. When bucking on a

slope, always stand on the uphill side.

 Log supported along entire length: Cut from top (overbuck), being careful to avoid cutting

into the ground (Fig. 13a).

 Log supported on 1 end: First, cut from bottom (underbuck) 1/3 diameter of log to avoid

splintering. Second, cut from above (overbuck) to meet first cut and avoid pinching (Fig.

13b).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXG1018 in the language / languages: English as an attachment in your email.

The manual is 0,51 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXG1018

Powerplus POWXG1018 User Manual - German - 28 pages

Powerplus POWXG1018 User Manual - Dutch - 28 pages

Powerplus POWXG1018 User Manual - French - 24 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Powerplus POWXG1018 Manual

Product: