645716
5
Zoom out
Zoom in
Previous page
1/10
Next page
POWX354 EN
Copyright © 2016 VARO P a g e | 5 www.varo.com
THINNING - Always read the paint manufacturers thinning recommendations or
instructions before using paint or other materials.
DISCONNECT FROM THE MAINS SUPPLY - Always disconnect from the mains supply
when filling the paint container or cleaning the spray gun.
SWITCH OFF WHEN NOT SPRAYING Avoid running the unit with the flow rate knob
fully closed for any length of time.
We accept no responsibility for damage caused by the use of unsuitable
substances, or paints that have not been thinned correctly, and any health
hazards that arise from lack of adequate ventilation.
5.1 Immediately switch off the spray gun when:
Interruption in the mains plug, mains lead or mains lead damage.
Defect switch.
Smoke or stench of scorched isolation.
5.2 Coating materials suitable for use
Water- and solvent-based paints, finishes, primers, 2-component paints, clear finishes,
automotive finishes, staining sealers and wood sealer-preservatives.
5.3 Coating materials not suitable for use
Wall paints (emulsion paints) etc., alkali and acidic paints. Coating materials with a flash point
below 21 °C.
5.4 Preparation of the coating material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted.
Stir the material up and put the required amount into the paint container.
Thinning recommendation
undiluted
undiluted
dilute by 5 - 10%
If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
6 START-UP
Before connecting to the mains supply, be sure that the supply voltage is identical with the
value given on the rating plate.
Unscrew the container from the spray gun.
Aligning suction tube (Fig. 2).
If the suction tube is positioned correctly, the container contents can be sprayed without
almost any residue.
When working on lying objects: Turn the suction tube forwards (Fig. 2 A).
Spraying work when working on overhead objects: Turn the suction tube rearwards (Fig. 2 B).
Set the container on a sheet of paper, pour in the prepared coating material and screw the
container tightly onto the spray gun.
Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!
Adjust the spray setting on the spray gun.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWX354 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWX354 in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWX354

Powerplus POWX354 User Manual - German - 11 pages

Powerplus POWX354 User Manual - Dutch - 11 pages

Powerplus POWX354 User Manual - French - 11 pages

Powerplus POWX354 Additional guide - All languages - 5 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info