POWX1347MC EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
▪ If the point has become worn, pull off the sand paper, turn it through 120º and place it on
again, or change the sanding paper.
7.3 Mounting dust extraction (Fig. 4)
Take the dust adaptor (10) and screw it on the bottom part of the machine. Keep in mind that
the screw has to be on the bottom part of the dust adaptor, this way you can screw it nice and
gently in the screw hole. After this piece is mounted on the machine, you can attach the dust
pipe (11) on the dust adaptor. Give the pipe a firm push. You can always adjust the direction
of the pipe by moving it a bit in the desired direction.
8 OPERATION
8.1 Switching ON/OFF (Fig. 5)
First check that the cable and plug are not damaged.
▪ Connect the plug to the power supply.
▪ Switching the power tool ON: slide ON/OFF switch button (2) forward onto position (I).
▪ Switching the power tool OFF: slide ON/OFF switch button backward onto position (O).
8.2 Speed adjusting (Fig. 6)
The tool can be set at 6-speed adjustment positions. The "1" position indicates the lowest and
the "6" position indicates the highest speed, you can adjust different speed by turning the
speed control dial (4) from "1" to "6" position. The operator may have to vary the speed to
optimize working efficiency.
8.3 Application tips
8.3.1 Selecting the Application Tool/Accessory
