POWX1341 EN
Copyright © 2018 VARO P a g e | 6 www.varo.com
▪ Make sure that the workpiece is sufficiently supported or clamped. Keep your hands away
from the surface to be cut.
▪ Always wear safety goggles and hearing protection. If desired or required also use another
kind of protection like for example an apron or helmet.
▪ Ensure that mounted wheels and points are fitted in accordance with the manufacturer’s
instructions.
▪ Ensure that blotters are used when they are provided with the bonded abrasive product
and when they are required.
▪ If a guard is supplied with the tool never use the tool without such a guard.
▪ For tools intended to be fitted with threaded hole wheel, ensure that the thread in the
wheel is long enough to accept the spindle length.
▪ Ensure that ventilation openings are kept clear when working in dusty conditions. If it
should become necessary to clear dust, first disconnect the tool from the mains supply
(use non-metallic objects) and avoid damaging internal parts.
▪ Though poor conditions of the electrical mains, shortly voltage drops can appear when
starting the equipment. This can influence other equipment (eq. blinking of a lamp). If the
mains-impedance Zmax <0.348 Ohm, such disturbances are not expected. (In case of
need, you may contact your local supply authority for further information.
6.1 Additional safety instructions
Do not use the tool on light metal with a magnesium content exceeding
80%, as this type of metal is flammable.
The work head may continue rotating after the tool is turned off.
On the upper side of the tool there is a spindle-lock button. Do not press
the spindle-lock button while the tool is running.
▪ Make sure that the accessories used are suitable for the maximum speed stated in the
technical data.
▪ Make sure that the accessories are mounted according to the instructions.
▪ Only use accessories and adapters supplied by the manufacturer.
▪ Make sure that sparks cannot hit any persons or set flammable materials alight.
▪ Always wear safety goggles, hearing protection and if necessary other protective means,
such as working gloves, hard hat, etc.
7 ASSEMBLY
Before mounting an accessory, always unplug the tool.
7.1 Changing the attachment tools (Pig. 1 & 2)
The small accessory attachments such as the grinding stones or cutting discs may be attached
directly to the multi tool.
If required , these tools may also be attach to the flexible drive shaft.
7.2 Auxiliary handle (Fig. 3, 4 & 5)
▪ Remove the ring by turning it anticlockwise.
▪ Mount the auxiliary handle on the thread, and fix it with the additional (smaller) ring by
turning the ring clockwise.
