676311
8
Zoom out
Zoom in
Previous page
1/13
Next page
POWX1331LI EN
Copyright © 2017 VARO P a g e | 8 www.varo.com
This ensures good adhesion and prevents premature wear.
If the point has become worn, pull off the sand paper, turn it through 120º and place it on
again, or change the sanding paper.
9 OPERATION
9.1 Charging the battery pack (Fig. 4)
a. Plug
b. Charging socket
c. Adapter
d. Power indicator
The battery pack has been shipped in a low charge condition to prevent possible problem. You
should charge them prior to use.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles
(drilling followed by recharging) for the item to fully charge. The battery should only be used
indoors.
The battery as supplied is not fully charged. Therefore, let the tool charge initially for 7 hours.
After the initial Charge, under normal usage, your tool should be fully charged in 1 to 1,5 hours.
The battery pack will become slightly warm to the touch while charging, this is normal and
does not indicate a problem.
Do not place the charger in an area of extreme heat or cold, it will best at normal room
temperature.
Charging indication:
The adapter (c) has one LED light. (See Fig. 4)
1. Plug the adapter (c) into suitable power outlet socket. The power indicator (d) will light
green once the connection has successfully completed.
2. Plug the charger plug (a) into the charging socket (b) of battery pack (6) and ensure to
connect firmly. The power indicator (d) will be changed to red which on the adapter (c)
that means the battery pack is charging.
3. When the battery is loaded, the power indicator (c) change from red to green until the
charger disconnect from the mains.
NOTE: If the battery does not fit properly, disconnect it and confirm that the battery pack is the
correct model for this charger as shown on the specification chart.
Do not charge any other battery pack or any battery pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected.
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down to room
temperature before charging. This will extend the life of your batteries.
9.2 Removal / insertion of battery
WARNING: Before making any adjustments ensure the multi-use tool is switched off.
1 Hold the multi-use tool with one hand and the battery pack (6) with the other.
2 To install: pull and slide battery pack into battery port, make sure the latch (5) on the
both side of the battery snap into place and battery is secure before begging operation.
3 To remove: use your thumb and fingers, press the battery release latches in and pull
the battery pack off at the same time.
9.3 Speed adjusting (Fig. 3)
The tool can be set at 6-speed adjustment positions. The "1" position indicates the lowest and
the "6" position indicates the highest speed, you can adjust different speed by turning the
speed control dial (8) from "1" to "6" position. The operator may have to vary the speed to
optimize working efficiency.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWX1331LI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWX1331LI in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWX1331LI

Powerplus POWX1331LI User Manual - German - 14 pages

Powerplus POWX1331LI User Manual - Dutch - 14 pages

Powerplus POWX1331LI User Manual - French - 14 pages

Powerplus POWX1331LI Additional guide - All languages - 5 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info