POWX07587 EN
Copyright © 2017 VARO NV P a g e | 18 www.varo.com
9.9.8 Tilting the saw table
9.9.9 Unlocking the tool head in the lowest position
9.9.10 Installing or removing the sub fences R and L (Fig. 49)
CAUTION:
When cutting a workpiece over 20 mm thick, make sure that the sub fences R and L are
securely installed with a screw.
Removal of the sub fences R and L are convenient for cutting wide and thin workpiece.
When cutting a workpiece up to 20 mm thick and more than 180 mm wide, remove the sub
fences R and L by removing the screw shown in the figure.
When cutting a workpiece over 20 mm thick, install the sub fences R and L securely with a
screw.
Refer to the table below for the relation between the size of workpiece and use/unuse of sub
fences R and L. (Fig. 51)
9.9.11 Cable holders (electric cable)
Install the two included cable holders in the provided openings at the left side of the table,
resp. left and right from the dust bag.
10 OPERATION
CAUTION:
▪ Before use, be sure to release the handle from the lowered position by pulling the stopper
pin and turning it to the angle of 90°.
▪ Make sure the blade is not contacting the workpiece, etc. before the switch is turned on.
10.1 Cutting as mitre saw
WARNING: Make sure that the lower blade guard C is installed before using
in Mitre saw mode.
CAUTION:
▪ Do not apply excessive pressure on the handle when cutting. Too much force may result
in overload of the motor and/or decreased cutting efficiency. Push down handle with only
as much force as is necessary for smooth cutting and without significant decrease in blade
speed.
▪ Gently press down the handle to perform the cut. If the handle is pressed down with force
or if lateral force is applied, the blade will vibrate and leave a mark (saw mark) in the
workpiece and the precision of the cut will be impaired.
10.1.1 Press cutting
Secure the workpiece against guide fence and turn table. Switch on the tool without the blade
making any contact and wait until the blade attains full speed before lowering. Then gently
lower the handle to the fully lowered position to cut the workpiece. When the cut is completed,
switch off the tool and WAIT UNTIL THE BLADE HAS COME TO A COMPLETE STOP before
returning the blade to its fully elevated position.
10.1.2 Mitre cutting
Refer to the previously covered “Adjusting the Mitre angle”.
