POWX07587 EN
Copyright © 2017 VARO NV P a g e | 13 www.varo.com
CAUTION:
▪ The stopper pin cannot be turned with the tool head at fully lowered position. At this time,
turn the knob counterclockwise slightly and the stopper pin can be released. (Fig. 16)
9 ASSEMBLY
CAUTION:
▪ Always be sure that the tool is switched off and unplugged before carrying out any work on
the tool.
9.1 Table height two way set up
The table height can be set up in two ways, high or low table.
WARNING: Before falling down the tool backwards, always set the tool in
the Mitre saw mode and lock the tool head in the lowest position.
9.1.1 High table set up (Fig. 17)
To set up the tool with high table, proceed as follows.
▪ Fall down the tool carefully BACKWARDS without fail while holding it with both hands.
▪ Loosen the wingnut of the leg as much as necessary and fold the leg down, then retighten
the wingnut.
9.1.2 Low table set up
▪ Fold in the 4 legs. To do so:
▪ Fall down the tool carefully BACKWARDS without fail while holding it with both hands.
▪ untighten the wing nut of each leg seperatly until you can turn the leg 90° , aligned with
tabel. Then tigthen the wing nut again
▪ Return the tool to the upright position.
9.2 Installing or removing saw blade
CAUTION:
▪ Always be sure that the tool is switched off and unplugged before installing or removing
the blade.
▪ Lower the tool head to the lowest position and lock it with the stopper pin (27) (Fig. 16).
▪ Use only the socket wrench 6mm hex key provided to install or remove the blade. Failure
to do so may result in overtightening or insufficient tightening of the hex bolt. This could
cause an injury. Move up the handle in the fully raised position. Press the shaft lock to lock
the spindle, use the socket wrench 6mm hex key to loosen the hex bolt clockwise. (Fig.
18) Heben Sie die Schutzhaube A mit dem Hubhebel an, während Sie den Hebel am
Handgriff nach links drücken. Remove the hex bolt, outer flange and blade. (Fig. 19) To
install the blade, mount it carefully onto the spindle, making sure that the direction of the
arrow on the surface of the blade matches the direction of the arrow on the blade case.
Install the outer flange and hex bolt, and then use the socket wrench 6mm hex key to
tighten the hex bolt (lefthanded) securely counterclockwise while pressing the shaft lock.
▪ Lift the tool head again up to the highest position. In order to do so, the stopper pin (27)
must be pulled to the right side, turned around 180 degrees and then released (status:
unlocked).
NOTE: When installing a saw blade, be sure to insert it between the blade
guard (6) at first and then raise it so that the blade is finally placed in the
blade guard. (Fig. 20 & 21)
