POWX075751DB EN
Copyright © 2022 VARO P a g e | 7 www.varo.com
▪ Do not maltreat the cable. Never pull on the cable, for removing the plug from the socket.
Do not expose the cable to heat, oil, water or sharp edges.
▪ Some types of dust that is generated while working with the saw may contain chemicals,
which can cause cancer, birth defects or other genetic damages. Some examples of these
substances are:
▪ Lead derived from paints containing lead;
▪ Arsenic and chrome from chemically treated wood.
▪ The hazard to your health from such exposures is dependent on how frequently you do
this kind of work.
▪ Measures for reducing your exposure to such chemicals: Always work in well-ventilated
surroundings and with certified safety equipment, such as dust masks that have been
specially designed for filtering out microscopic particles.
▪ For sawing operations, connect the equipment to a dust exhaust system.
▪ The guard may be lifted up while positioning a workpiece, or for easier access during
maintenance works. Make sure that the saw guard has been lowered and is positioned flat
against the sawing table, before connecting your tool to the mains supply.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
Warning! The laser beam potentially causes eye damage. Do not look or
stare into the laser beam.
▪ During use, do not point the laser beam at people, directly or indirectly through reflecting
surfaces.
▪ This laser complies with class 2 according to the relevant standard. The unit includes no
servicing components. Do not open the housing for any reason. If the unit is damaged,
have the damage repaired by an authorized repair agent.
▪ Laser viewing glasses are not protective glasses against laser radiation.
8 ASSEMBLY
Disconnect the power plug before carrying out any adjustments or
maintenance.
Do not operate this mitre saw until it has been fully assembled and correctly prepared for use
in accordance with this instruction manual.
8.1 Assembling the saw (Fig. 1 - 6)
▪ To adjust the turntable (16), pull the indexed position lever (12) upwards with your index
finger.
▪ Rotate the turntable (16) and pointer (14) to the desired angle on the scale (15) and lock in
place by turning the turntable handle clockwise (13).
▪ Pressing the machine head (5) lightly downwards and pulling the locking pin (24-Fig.3)
from the motor bracket at the same time disengages the saw from the lowest position.
▪ It is possible to secure the clamping device (8) to the left or right on the stationary saw
bench (17).
▪ Attach the workpiece supports (9) to the stationary saw bench (17) as shown in Figure
6a,b,c and push all the way through. Secure the shafts with the retaining springs to
prevent them from slipping out accidentally. Then fasten in the desired position with the
screws (10-Fig.6b).
▪ It is possible to tilt the machine head (5) a max. 45° to the left by loosening the lock screw
(22), to tilt the machine head (5) to the right to max. 45° the safety bolt (22a) must also be
loosened.
