POWX075740DB EN
Copyright © 2022 VARO P a g e | 9 www.varo.com
▪ Pull down on the saw head to check the current setting.
▪ To change the setting, first loosen the knurled depth stop nut on the depth stop bolt. Turn
the depth stop bolt clockwise to decrease depth and counterclockwise to increase depth.
Tighten the depth stop nut after adjustment.
▪ If needed, push the depth stop to the right to temporarily disable it.
9.9 Switching ON / OFF
For your safety use both hands to switch the power tool on and off.
▪ Connect the power tool to the power supply.
▪ To turn the machine on, simultaneously press the main switch (14) and locking button
(24).
▪ When you want to turn off the machine, you have to release the on/off switch (14).
▪ Important! Place the material you want to saw flat on the machine surface and secure with
the clamping device (11) so that the material cannot move while you are cutting.
▪ After switching on the saw, wait for the blade (2) to reach its maximum speed.
▪ Press the release lever (15) sideways and, using the handle (13), apply steady and light
downward pressure to move the machine head through the workpiece.
▪ When the cut is completed, return the machine to its top parking position and let go of the
On/Off switch.
Caution! A return spring causes the machine head to rise automatically at the end of the cut.
Do not let go of the handle (13) as soon as the cut is completed but steady the machine head
and allow it to rise slowly.
9.10 Laser
▪ You can switch the laser ON and OFF with the switch (29)
▪ The laser (22) directs a beam onto the workpiece
▪ Extremely precise cuts can be made using the laser function.
9.11 Dust bag
To attach the dust bag (18), fit it onto the dust extraction adapter. When the dust bag is about
half full, remove the dust bag from the tool and empty it.
9.12 Sawing
Make sure the saw blade doesn’t block while you are sawing. It causes
damage to and burning of the motor. If there is a blockade of the saw blade,
please loosen the switch immediately to prevent damage at the motor.
▪ Clamp the work piece firmly.
▪ Set the required horizontal mitre angle or the required vertical bevel angle.
▪ Switch on the power tool.
▪ Move the handle (13) slowly downwards.
▪ For long workpieces you should use the slide; loosen the locking knob for this purpose.
▪ Saw trough the work piece.
▪ Switch off the power tool.
▪ Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
9.13 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (4) or the saw table (5).
