POWX0361 EN
Copyright © 2022 VARO P a g e | 5 www.varo.com
▪ This laser complies with class 2 according to EN 60825-1:2007. The unit includes no
servicing components. Do not open the housing for any reason. If the unit is damaged,
have the damage repaired by an authorized repair agent
7 OPERATING INSTRUCTIONS
7.1 Starting up (Fig. 1)
7.1.1 Instant response operation
Switching on: Press the On/Off switch.
Switching off: Release the On/Off switch
7.1.2 Continuous operation
Switching on: Press the On/0ff switch, keep pressed and lock with the locking button Switching
off: Press the On/Off switch and release
7.1.3 Electronic speed control setting
Using the speed regulator (4) on the top, you can pre-set any speed. Turn the speed regulator
(4) to a higher number for a higher speed and turn it to a lower number for a lower speed. The
ideal cutting rate depends on the specific material and working conditions.
The general standards for setting the cutting speed for power tools apply here.
▪ Steel: slowest cutting speed
▪ Aluminium, plastic, hardwood: medium cutting speed.
▪ Soft wood: high cutting speed.
When processing metals you should use suitable lubricants/coolants to protect the saw blade
– just a little oil for steel, and spirit or petroleum for aluminium, as required. For plastic material
water is normally sufficient as the coolant/lubricant.
7.2 Changing the saw blade (Fig. 2)
Push the blade holder with the blade clamp all the way to the front and than slide the blade
(with the teeth to the front) into the guide groove.
7.3 Adjusting the base (Fig. 3)
Loosen the base plate by pulling the lever for angle cutting adjustment which located on the
underside of the tool
Move the base plate forward and tilt it until the desired angle is obtained the angle can be
between 0°and 45°(left and right).
Move the base plate back to ensure the slot of base plate is engaged with gear casing.
Press the lever for angle cutting adjustment to lock position (original position) and ensure it
firmly.
For accurate cut it is necessary to make a trial cut, measure the work and reset the angle until
the correct setting is achieved.
7.4 Dust extraction
The jigsaw is equipped with a dust extractor socket. You can connect your vacuum cleaner to
the socket at the rear of the jigsaw. If you require a special adapter, please contact the
manufacturer of your vacuum cleaner.
7.5 Using the laser and LED-light (Fig. 4)
You can use LED-light to enlighten the approximity of the cutting position.
The laser beam projects a red cutting line on the workpiece.
▪ Switch the laser on by means of the on/off switch (6).
▪ Place the machine on the workpiece with the saw marking above the start of the cutting
line.
▪ Check that the laser line aligns with the cutting line as marked on the workpiece.
▪ Switch on the machine.
