582282
7
Zoom out
Zoom in
Previous page
1/10
Next page
POWX0073LI EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
8 OPERATION
8.1 Charging the battery pack (Fig. 2)
The battery pack for this tool is supplied in a low charge condition to prevent possible
problems, therefore, you have to charge the battery before first use.
Note: Batteries will not reach full charge the first time they are charged.
Allow several cycles for the item to fully charge. The battery should only be
charged indoors.
After normal use, about 1 hour of charging time is required for the battery to be fully charged.
The battery pack will become slightly warm while charging, this is normal and does not
indicate a problem.
Do not place the charger in an area of extreme heat or cold. Best is at normal room
temperature.
8.1.1 Charging indication
The charger has 2 LED lights (red and green).
Slide the battery pack in the charger as shown in fig. 2. Make sure there is proper contact
with the charger.
When charging the green is constantly lit and the red is flashing.
When fully charged both lights will be constantly lit.
8.2 Inserting and removing the battery (Fig. 3)
Remove the battery pressing the battery latches and at the same time pull the battery
pack off.
To insert the battery, push the battery pack onto the contacts of the tool.
8.3 Switch on/off (Fig. 4)
The impact screwdriver is started and stopped by depressing and releasing the ON/OFF
switch trigger (7).
This impact screwdriver is equipped with an electric brake, when the ON/OFF switch
trigger (7) is released completely, the chuck stops immediately.
8.3.1 Switch lock
The ON/OFF switch trigger (7) can be locked if the reverse switch (3) is in the center
position. (Fig. 5)
This helps to reduce the possibility of accidental starting when not in use.
8.3.2 Direction of rotation (Fig. 5)
To select forward rotation, release the on/off switch trigger (7) and push the reverse switch
(3) to left side of the tool.
To select reverse rotation, push the reverse switch (3) to right side of the tool.
When the reverse switch (3) is in center position, the ON/OFF switch trigger (7) is locked.
8.3.3 Variable speed
This tool has a variable speed ON/OFF switch trigger (7) that delivers higher speed and torque
with increased trigger pressure.
Speed is controlled by the amount of pressure on the ON/OFF switch trigger (7).
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWX0073LI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWX0073LI in the language / languages: English as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWX0073LI

Powerplus POWX0073LI User Manual - German - 10 pages

Powerplus POWX0073LI User Manual - Dutch - 10 pages

Powerplus POWX0073LI User Manual - French - 10 pages

Powerplus POWX0073LI Additional guide - All languages - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info