POWX00408 EN
Copyright © 2022 VARO P a g e | 6 www.varo.com
▪ Recharge only with the charger specified by the manufacturer. A charger that is suitable
for one type of battery, it may create a risk of fire when used with another battery.
▪ Do not charge other batteries. The battery charger is suitable only for charging our lithium
ion batteries within the listed voltage range. Otherwise there is danger of fire and
explosion.
▪ Keep the battery charger clean. Contamination may cause the danger of electric shock.
▪ Check the battery charger, cable and plug each time before using. Do not use the battery
charger when defects are detected. Do not open the battery charger yourself and have it
repaired only by qualified personnel using original spare parts. Damaged battery chargers,
cables and plugs increase the risk of electric shock.
▪ Do not operate the battery charger on easily inflammable surfaces (e. g. paper, textiles,
etc.) or in combustible environments. There is danger of fire due to the heating of the
battery charger during charging.
▪ Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or burns.
▪ Do not open the battery yourself. There is danger of a short circuit.
▪ Protect the battery against heat, e.g., including against continuous sun irradiation and fire.
There is a danger of explosion.
▪ Do not short-circuit the battery. There is a danger of explosion.
▪ In case of damage and improper use of the battery, vapours may be emitted. In case of
complaints, provide for fresh air and consult a physician. The vapours can irritate the
respiratory system.
7 OPERATION
7.1 Charging procedure (Fig.B)
The Li-ion battery is protected against deep discharging. When the battery is empty, the
machine is switched off by means of a protective circuit: The bit holder no longer moves.
The screwdriver has a built in battery, do not try to remove the battery.
NOTE: Not every USB A port on laptops, PC’s etc. is a power source, some are
only for data transfer. Devices can not be charged via data transfer only USB A
ports. It does not mean that your device is defective. Simply look for another USB
A port to charge your device.
NOTE: When connecting to a built in USB A port in another source device (e.g.
laptop, PC, etc.) make sure this device is switched on and connected to a mains
socket. Charging will only start when these requirements are met. Power banks
are however an exception and are an autonomous power source.
▪ The screwdriver can only be charged via a powered USB A port, for example in a
power bank, laptop, PC, or a USB charger (not included) from your smartphone.
▪ Plug the USB C connector of the charging cable (10) in to the USB C port (9)at the
bottom of the screwdriver handle and the USB A connector to the powered USB A
port.
▪ In case of a power bank, charging starts as soon as the USB A cable plug is
inserted in the USB A port.
▪ In case of using a USB charger (e.g. smartphone charger) , make sure it is plugged
in to a mains socket.
