POWPG40220 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
WARNING! The line cut-off blade (12) on the safety guard is sharp. Avoid
contact with the blade. Failure to avoid contact can result in serious personal
injury. Never use the grass trimmer unless the guard is properly fitted.
7.2 Fitting the auxiliary handle (Fig. 2)
Depress and keep hold the adjustment button (3), insert the auxiliary handle onto the correct
position, adjust the handle to the most comfortable position and release the adjustment
button.
8 PREPARING THE TRIMMER FOR USE
Turn the shaft lock sleeve (4) clockwise to unlock. You can slide the telescopic tube up or
down to achieve the most comfortable working height. (Fig. 3)
NOTE: If necessary, you can choose the desired main handle position when
the shaft lock sleeve is unlock.
8.1 Starting / Stopping the trimmer (Fig. 4)
Attach the outlet end of an extension cord to the plug on the rear of the grass trimmer.
NOTE: Use only approved outdoor extension cords.
Route the extension cord through the slot located on the rear of the grass
trimmer housing and place underneath the cord holder.
To start the line trimmer, squeeze the safety switch (13), then press the switch trigger (1).
To stop the line trimmer, release the switch trigger.
9 OPERATING THE TRIMMER
▪ Hold the line trimmer as shown in fig. 5
▪ Gently swing the trimmer from side to side .
▪ In order to achieve optimum cutting results, only cut dry grass.
▪ When cutting long or thick grass, start at the top of the grass blades and gradually work
down to the bottom.
▪ If the line trimmer starts running slowly, reduce the amount of material you are trying to
cut.
9.1 Adjusting trimmer head angle (Fig. 6)
The trimmer head can be pivoted to seven different positions.
Unplug the line trimmer.
Push the pivot button (14) and move the trimmer head up or down to one of the seven
positions indicated by the notches.
NOTE: Adjust the trimmer head to the first, second and third notches for
trimming and notches four, five six and seven for edging, based on preferred
trimming and edging position.
Make sure the trimmer head is securely locked into place before resuming
work.
