POWPG40140 EN
Copyright © 2019 VARO P a g e | 12 www.varo.com
When the inside of the fuel tank is dirty, it can be cleaned by rinsing the tank
out with gasoline.
11.3 Carburettor adjustment
The carburettor was pre-set at the factory for optimum performance.
When further adjustment is necessary, contact the service department.
12 TECHNICAL DATA
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
14 STORAGE
WARNING: Failure to follow these steps may cause varnish to form in the
carburettor and lead to difficult starting or permanent damage after storage.
▪ Clean outside surface of unit.
▪ Drain fuel from the fuel tank.
▪ After fuel is drained, start engine.
▪ Run engine at idle until unit stops. This will purge the carburettor of fuel.
▪ Allow engine to cool (approx. 5 minutes).
▪ Using a sparking plug wrench, remove the sparking plug.
▪ Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace sparking plug.
▪ Store unit in a cool, dry place away from any source of ignition such as an oil burner,
water heater, etc.
▪ Put the sleeve on when not in use or in transportation.
