POWPG20130 EN
Copyright © 2019 VARO P a g e | 19 www.varo.com
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
14 STORING A CHAIN SAW
Caution: never store a chain saw for longer than 30 days without performing the following
procedures. Storing a chain saw for longer than 30 days requires storage maintenance. Unless
the storage instructions are followed, fuel remaining in the carburettor will evaporate, leaving
gum-like deposits. This could lead to difficult starting and result in costly repairs.
▪ Remove the fuel tank cap slowly to release any pressure in tank. Carefully drain the fuel
tank.
▪ Start the engine and let it run until the unit stops to remove fuel from carburettor.
▪ Allow the engine to cool (approx. 5 minutes).
▪ Using a spark plug wrench, remove the spark plug.
▪ Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace spark plug. (Fig.24)
Note: store the unit in a dry place and away from possible sources of ignition
such as a furnace, gas hot water heater, gas dryer, etc.
Removing a unit from storage
▪ Remove spark plug.
▪ Pull starter rope briskly to clear excess oil from combustion chamber.
▪ Clean and gap spark plug or install a new spark plug with proper gap.
▪ Prepare unit for operation.
▪ Fill fuel tank with proper fuel / oil mixture. See fuel and lubrication section
