POWPG10260 EN
Copyright © 2020 VARO P a g e | 8 www.varo.com
7 ASSEMBLY
7.1 Folding handle
▪ Fix the lower handlebars into the unit body with the locking knobs. (Fig 1A)
▪ Release the upper handlebars for folding. Connect the upper handle and the lower handle
with the locking lever. (Fig 1B)
▪ Attach the cable-clamp to the position shown and then attach the cable. (Fig 1C-D)
7.2 The grass catcher (5)
▪ To fit: Raise the rear cover and hitch the grass catcher on rear of mower. (Fig 2A-B)
▪ To remove: grasp and lift rear cover, remove grass catcher.
7.3 Adjustment of cutting height (7)
Apply outward pressure to disengage lever from rack. Move lever forward or back to adjust
height. (Fig 3)
The height (the blade to the ground) can be adjusted from 30mm (the lowest position) to
75mm (the highest position), 7 height positions (30, 35, 40, 48, 55, 65, 75mm).
Warning: Make this adjustment only when blade is stopped.
Warning: Disconnect the electric cord from the power supply.
7.4 Adjustment for an appropriate angle (Fig 4)
▪ Pull the locking lever opening.
▪ By rotating the upper handle, which acts on the adjustment mechanism for angle
adjustment, a suitable angle can be adjusted in the range of -20 º to 20 º
▪ Push the locking lever closed to connect the lower handle and the upper handle.
8 MULCHING
8.1 What is mulching
When mulching, the grass is cut in one working step, then finely chopped and returned to the
grass strip as natural fertilizer.
Hints for mulch-mowing:
▪ Regular cut-back by max.2cm from 6cm to 4cm grass height.
▪ Use a sharp cutting knife
▪ Do not mow wet grass
▪ Set to max. motor speed
▪ Only move at working pace
▪ Regularly clean mulching wedge, housing inner side and mowing blade
8.2 Different uses
8.2.1 Mulching mower
WARNING: only with a stopped motor and standstill cutter.
▪ Raise the rear cover and remove the grass catcher. (Fig A)
▪ Push the mulching wedge into the deck. Lock the mulching wedge with the button into the
opening on the deck.
▪ Lower the rear cover again. (Fig 5B)
