POWESET6 EN
Copyright © 2017 VARO P a g e | 5 www.varo.com
▪ Do not allow children to have access,
▪ Make sure you have a secure stand on ladders or scaffolding when using the drill
freehand.
▪ Localize lines with a line detector in walls where power, water or gas lines are laid
invisibly.
▪ Wear protection goggles and use a dust mask for dust-producing work.
▪ Always arrange for a qualified electrician to carry out repairs
▪ Use only original replacement parts
▪ The level of noise at the workplace may exceed 85 dB (A). In this case you will need to
introduce noise protection measures for the user. The noise generated by this electric tool
was measured in accordance with EN 50114-1.
Always use ear-protection, when machine is in use!
Recommended nominal operating-time: approx. 20 minutes under
permanent load.
Rest after permanent operation: approx. 5-10 minutes.
7 OPERATION
WARNING: Prior to assembly and adjustment always pull out the power
plug from the mains socket.
7.1 Changing drill or screwdriver bit
This drill has a keyless chuck with lock (1) to prevent the bit or drill from loosening.
▪ Hold ring B of the drill chuck tight with one hand.
▪ Turn upper ring A anticlockwise with the other hand until the drill chuck opening is large
enough to accept the tool.
▪ Insert the drill or the screwdriver bit into the drill chuck.
▪ Turn ring B clockwise until the tool is snapped into lock place and clamped tightly.
▪ Remove the tool in the opposite way.
7.2 Switching on/off (Fig. 1)
▪ Connect the plug to the power supply. The power-on indicator (9) is illumed until the tool
disconnect from the power mains.
▪ To start the tool by squeezing the ON/OFF switch (4).
▪ Release the ON/OFF switch to stop the tool.
▪ If you press the lock-on button (6) while the ON/OFF switch is depressed, the ON/OFF
switch is kept in the operating position.
▪ To release the ON/OFF switch (4) and turn the tool off.
