POWEG63773X EN
Copyright © 2022 VARO P a g e | 10 www.varo.com
CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline
near an open flame
CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methane
can attract moisture which leads to separation and formation of acids during
storage). Acidic gas can damage the fuel system of an engine while in
storage. To avoid engine problems, the fuel system should be emptied before
storage (See chapter Storage, further in this manual)
Gasoline is extremely flammable, and gasoline vapor can explode, causing
serious injury or death. Use extreme care when handling gasoline. Keep out
of reach of children.
Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow flames or
sparks in the area where the engine is refueled or where gasoline is stored. Avoid repeated or
prolonged contact with skin or breathing of vapor.
After refueling, tighten the fuel tank cap securely. If any fuel was spilled, make sure the area is
dry before starting the engine.
10 OPERATION
10.1 Starting the engine
10.1.1 Primer bulb (Fig. 7)
In cold condition, it’s necessary to push the primer bulb (10) on the air filter (12) before pulling
the starter handle (4).
Prime only for cool engine use:
We also should put more fuel to air mix for easy start. When you push the primer bulb (10), it
will pump the fuel direct from the carburetor to the combustion chamber.
▪ Pull back on the brake lever and hold it against the handle. (Fig. 8)
▪ Release the drive lever (3). This will prevent the mower from moving forward when you
operate the starter.
▪ With the starter handle (4) in its support, take the starter handle (4) with your right hand
and pull slowly until resistance is detected, then pull energetically on the starter handle (4)
with starter rope through the support. (If the cold start is not sufficient enough, repeat this
operation 2 or 3 times). (Fig. 9)
10.1.2 Operating the controls for mowing
Blade is in action as soon as engine started. While the machine is working hold the brake
lever (2) in working position. The engine will stop as soon as you release the brake lever (2).
Release the brake lever (2) to stop the engine whenever you need to leave the mower.
