POWEG2005 EN
Copyright © 2022 VARO P a g e | 18 www.varo.com
Warning: all cutting teeth must be similarly long. Different length of the teeth
can cause rough run of the chain or its rupture, as well.
▪ Minimum length of the teeth must be 4 mm. If they are shorter, remove the saw chain.
▪ Angles, which the teeth are under, must be followed.
▪ To sharpen the chain basically, make 2 to 3 pulls of the file from the inside out.
Warning: after 3 to 4 of your sharpening of the cutting teeth, have the saw
chain sharpened in any authorised service. They will sharpen the depth
limiter as well, which provides the distance.
Chain sharpening
The pitch of the chain (Fig. 33) depends on the model.
Sharpen the chain using protective gloves and a round file of ø5/32” (4 mm).
Always sharpen the cutters only with outward strokes (Fig. 34) observing the values given in.
After sharpening, the cutting links must all have the same width and length.
Warning: a sharp chain produces well-defined chips. When your chain starts
to produce sawdust, it is time to sharpen.
▪ After every 3-4 times the cutters have been sharpened you need to check the height of the
depth gauges and, if necessary, lower them using the flat file and template supplied
optional, then round off the front corner (Fig. 35).
WARNING: Proper adjustment of the depth gauge is as important as proper
sharpening of the chain.
12.5 Guide bar
The bar should be reversed every 8 working hours to ensure uniform wear. Keep the bar
groove and lubrication hole clean using a bar groove cleaner (optional) (Fig. 36)
Warning: never mount a new chain on a worn sprocket or self-aligning ring.
Bar wear - turn guide bar frequently at regular intervals (for example, after 8 hours of use), to
ensure even wear on top and bottom of bar.
Oil passages - oil passages on the bar should be cleaned to ensure proper lubrication of the
bar and chain during operation.
Note: the condition of the oil passages can be easily checked. If the
passages are clear, the chain will automatically give off a spray of oil within
seconds of starting the saw. Your saw is equipped with an automatic oiler
system.
