POWEB2510 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
9 ASSEMBLY
9.1 Install or remove the saw blade (Fig 3)
WARNING: Before making any adjustments ensure the saw is switched off
with the lock-off button in the centre position and remove the battery from
the saw.
To avoid accidental start, check to make sure lock-off button is not engaged
prior to plugging in tool and you finger is not touching the on/off switch
trigger.
▪ Rotate the Quick-release blade clamp (2) anticlockwise with hand.
▪ At the same time push blade (6) to the deepest position, then release the quick-release
blade clamp (2). Make sure it is securely fastened.
▪ When removing the saw blade (6), follow the above procedure in reverse order.
WARNING! Before plugging in battery pack, always pull on the blade to
make sure it is securely locked in the clamp. Failure to do so may result in
serious injury.
10 OPERATION
10.1 Switch on/off (Fig.4)
▪ Make sure the battery pack is installed.
▪ Push the lock-off button (3) towards left or right and squeeze the ON/OFF switch trigger
(4).
▪ To switch off simply release the ON/OFF switch trigger (4).
10.2 To change angle of the pivot shoe assembly (Fig. 5)
The pivot shoe assembly can be adjusted in a suitable angle by hand which is convenient for
operating this tool.
10.3 To change position of the pivot shoe assembly (Fig 6)
▪ Remove the battery from your saw.
WARNING: Failure to unplug your saw could result in accidental starting
causing serious injury.
▪ Loosen the both cap screw in the gear frame with hex key.
▪ Reposition pivot shoe assembly in or out.
▪ Retighten both cap screw securely. Do not over tighten cap screw.
▪ Remove hex key.
WARNING: Cutting into electrical wiring in walls can cause blade, blade
clamp, and saw bar assembly to become electrically live. Do not touch
metal parts when cutting into a wall; grasp only the insulated gripping
surfaces provided by the tool. Make sure hidden electrical wiring, water
pipes, and mechanical hazards are not in the blade path when cutting into a
wall.
