POWEB2010 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
Note:If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
NOTE: Remove battery pack from charger stand which use your thumb or
fingers, press the battery’s release button in and pull the battery pack off at
the same time.
9.2 Inserting and removing the battery (Fig 2)
WARNING: Before making any adjustments ensure the drill is switched off
with the direction of rotation selector in the centre position
▪ Hold the tool with one hand and the battery pack (6) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
9.3 Selecting correct socket
Always use the correct size socket for bolts and nuts. An incorrect size socket will result in
inaccurate and inconsistent fastening torque and /or damage to the bolt or nut. Refer to
accessories section for socket size.
9.4 Installing or removing socket (Fig. 3)
▪ Always be sure that the tool is switched off and the battery pack is removed before
installing or removing the socket.
▪ To install the socket, push it onto the anvil of the tool until it locks into place. To remove
the socket, simply pull it off.
9.5 Switch (7)
The drill is started and stopped by depressing and releasing the ON/OFF switch trigger.
9.5.1 Switch lock (Fig 4)
The switch trigger can be locked in the center position.
This helps to reduce the possibility of accidental starting when not in use. To lock the switch
trigger, place the direction of rotation selector in the center position.
9.5.2 Direction of rotation (Fig 5)
Direction of rotation is controlled by the direction of rotation selector located above the switch
trigger.
