POWEB1520 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
2. Inspect the battery pack before charging, do not charge a cracked or leaking battery
pack.
9.1.1 Charger indications (Fig. 1)
Connect the charger to the power oulet socket
▪ Solid green: ready to charge
▪ Flickering red + solid green: charging
▪ Solid green + solid red: charged
Note:If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
NOTE: Remove battery pack from charger stand which use your thumb or
fingers, press the battery’s release button in and pull the battery pack off at
the same time.
9.2 Inserting and removing the battery (Fig 2)
WARNING: Before making any adjustments ensure the drill is switched off
with the direction of rotation selector in the centre position
▪ Remove the battery: press the battery release latch in and at the same time pull the
battery pack off.
▪ To insert the battery, push the battery pack onto the contacts of the tool.
9.3 Installing and Removing a Bit and a Drill (Fig 3)
This drill has a keyless chuck to prevent the bit or drill from loosening.
▪ Hold the soft grip of the cordless drill firmly with one hand.
▪ Turn ring A anticlockwise with the other hand until the drill chuck opening is large enough
to accept the tool.
▪ Insert the drill or the screwdriver bit into the drill chuck.
▪ Turn ring A clockwise until the tool is clamped tightly.
Remove the tool in the opposite way.
9.4 Switch (4)
The drill is started and stopped by depressing and releasing the ON/OFF switch trigger.
