POWE50102 EN
Copyright © 2018 VARO P a g e | 7 www.varo.com
▪ The hazard to your health from such exposures is dependent on how frequently you do
this kind of work.
▪ Measures for reducing your exposure to such chemicals: Always work in well-ventilated
surroundings and with certified safety equipment, such as dust masks that have been
specially designed for filtering out microscopic particles.
▪ For sawing operations, connect the equipment to a dust exhaust system.
▪ The guard may be lifted up while positioning a workpiece, or for easier access during
maintenance works. Make sure that the saw guard has been lowered and is positioned flat
against the sawing table, before connecting your tool to the mains supply.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
WARNING! The laser beam potentially causes severe eye damage. Never
look or stare directly into the laser beam.
During use, do not point the laser beam at people, directly or indirectly
through reflecting surfaces.
▪ The unit includes no servicing components. Do not open the housing for any reason. If the
unit is damaged, have the damage repaired by an authorized repair agent
8 ASSEMBLY
Disconnect the power plug before carrying out any adjustments or
maintenance.
Do not operate this mitre saw until it has been fully assembled and correctly prepared for use
in accordance with this instruction manual.
8.1 Assembling the extension hoops
▪ Loosen the allen screws of the side extension hoops
▪ Place the extension hoops in both side holes.
▪ Tighten the extension hoop screws and make sure that the extension hoops are secure
and cannot be moved during the operation.
8.2 Assembling the clamp
The clamp (5) can be installed on either left or right side of the guide fence. Insert the vise rod
into the hole in the guide fence and fasten with locking screw.
9 OPERATING INSTRUCTIONS
9.1 Transporting the mitre saw
To transport the power tool, use the retaining pin (18).
Pull the mitre saw downwards and lock it in the lowered position by pushing in the retaining
pin. That way, the saw is secured.
9.2 Dust and chip extraction
For integrated dust extraction, place the dust bag (17) on the sawdust outlet.
For external dust, you can use a vacuum cleaner hose.
The dust bag is only for a partial dust removal!
