POWE50001 EN
Copyright © 2018 VARO P a g e | 9 www.varo.com
8.10 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (6) or the saw table (8).
8.11 Replacing the saw blade (Fig. 2)
Disconnect the tool from the outlet before working on the saw blade.
Wait a while before touching the saw blade. It can be very hot.
The teeth of the saw blade are very sharp.
▪ Pull the mitre saw downwards and lock it in the lowest position by pushing the retaining
pin.
▪ Allow the mitre saw cutting head to rise to the upright position
▪ Loosen the cover plate screw (2) with a allen key.
▪ Press the spindle lock.
▪ Tilt the cover plate (3) upwards in order to make the axle bolt (4) accessible.
▪ Press the spindle lock button, holding it in firmly while turning the blade wrench clockwise.
The spindle lock will engage after turning the wrench. Continue to hold the spindle lock
button to keep it engaged, while turning the wrench clockwise to loosen the spindle bolt.
▪ Remove the spindle bolt (4), the blade collar (6) and the blade (7). Do not remove the
inner blade collar.
▪ Replace the saw blade (the tips of the sawing teeth have to point in the same direction as
indicated by the arrow on the cover) and then reassemble all parts in the reverse order.
▪ Turn the plastic cover back in its original position.
9 CLEANING AND MAINTENANCE
Before performing any work on the equipment, pull the power plug.
9.1 Cleaning
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
▪ Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Make sure no water can reach the inside of the power tool!
9.2 Connecting cable
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
10 TECHNICAL DATA
