POWE20030 EN
Copyright © 2018 VARO p a g e | 7 www.varo.com
You must keep the spindle lock pressed while you change the wheel !
For grinding wheels up to approx. 3 mm thick, screw on the flange nut with the flat side facing
the grinding wheel.
7.4 Special attention when starting the machine
▪ Clamp the workpiece and make sure that the workpiece cannot slide from under the
machine during the cutting activities.
▪ When working with the machine, always hold it firmly with both hands and provide for a
secure stance.
▪ Always direct the cable to the rear away from the machine.
▪ Insert the mains plug only when the machine is switched off.
▪ Apply the machine to the workpiece only when switched on
Never use the machine for grinding magnesium workpieces.
7.5 Switching on / off (Fig. 6)
Before working with the angle grinder, check that the voltage shown on the
machine’s model plate is the same as the mains voltage being used.
Before engage the ON/OFF switch trigger, check that the grinding disc is
properly fitted and run smoothly, the outer flange is well tightened.
7.5.1 Switching on
1. Connect the plug to the power supply. The power-on indicator (10) is illumed until the tool
disconnect from the power mains.
2. Push forward the ON / OFF switch with safety button (5) (See the arrow (1) on Fig. 6), and
at the same time depress it firmly inwards and keep it pressed (See the arrow (2)).
7.5.2 Switching off
▪ When you release the switch, the tool turns off.
▪ Do not let go of grinder until it has stopped running.
The wheel continues to rotate after the tool is switched off.
7.6 Adjusting the main handle position (Fig. 7)
The main handle (4) element can be pivoted by 90°to the right or left.
1. Depress position regulator button for main handle (4) and hold it in position.
2. Pivot the main handle in the desired direction.
3. Release position regulator button again in order to fix the main handle.
