POWDPG7560 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
▪ Do not cause short circuits. If connection is made between the positive (+) and negative (-)
terminal directly or via accidental contact with metallic objects, the battery is short circuited
and an intense current will flow causing heat generation which may lead to casing rupture
or fire.
▪ Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
▪ Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
Carefully wipe the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions below:
✓ Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.
✓ In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do not
incinerate the battery.
7.2 Chargers
▪ Never attempt to charge non-rechargeable batteries.
▪ Have defective cords replaced immediately.
▪ Do not expose to water.
▪ Do not open the charger.
▪ Do not probe the charger.
▪ The charger is intended for indoor use only.
8 CHARGING AND INSERTION OR REMOVAL OF BATTERY
8.1 Charger indications
Connect the charger to the power oulet socket
▪ Solid green: ready to charge
▪ Flickering red: charging
▪ Solid green: charged
▪ Solid green en red: battery or charger damaged
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery pack
that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
