795810
9
Zoom out
Zoom in
Previous page
1/14
Next page
POWDPG7551 EN
Copyright © 2021 VARO P a g e | 9 www.varo.com
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
8.2 Removal / insertion of battery
WARNING: Before making any adjustments ensure the tool is switched off
or remove the battery pack.
Hold the tool with one hand and the battery pack (9) with the other.
To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3 Battery capacity indicator (fig. 1)
There are battery capacity indicators (12) on the battery pack, you can check the capacity
status of the battery if you squeeze the button (13). Before using the machine, please press
switch trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LED’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
9 ASSEMBLY
9.1 Shaft assembly (Fig. 2-3)
Before starting to assemble the front tubular shaft to the tubular shaft of the
housing, the inner rubber cable protection must be removed!
Loosen the knob (14).
Pull the lock (15) outward and turn it left or right as far as it goes.
Slide the front tubular shaft onto the tubular shaft on the device housing.
Pull the lock (15) outward and turn it back to its original position.
Turn the front tubular shaft with a gentle rotating movement until the lock (15) clicks into
place in the bore on the front tubular shaft .
Fix the tubular shaft in place with the knob (14).
9.2 Bike handle installation (Fig. 4a-b)
Place handle between handle clamp and handle holder. Adjust the handle to an angle that
provides a comfortable working position and then tighten four screws(A) so that the handle
assembly cannot move.
Fix the cable with cable clamp to the top shaft
9.3 Installation protection guard (Fig. 5)
Slide the lower part of the protective cover with the knife onto the upper part of the protective
cover.
Fit the trimmer guard for use with the motor, then tighten 2 screws so that the guard assembly
cannot move.
Then mount the extra keep on the protective cover and secure with two screws.
9.4 Installing the harness (Fig. 6)
Adjust the harness hanger in a comfortable position
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWDPG7551 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWDPG7551 in the language / languages: English as an attachment in your email.

The manual is 0.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWDPG7551

Powerplus POWDPG7551 User Manual - German - 15 pages

Powerplus POWDPG7551 User Manual - Dutch - 15 pages

Powerplus POWDPG7551 User Manual - French - 15 pages

Powerplus POWDPG7551 Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info