POWDP7050 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
7.2 Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the machine is switched
off or remove the battery pack.
▪ Hold the tool with one hand and the battery pack (10) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
7.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (12). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LED’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
8 OPERATION
Speed 1, cut nozzle - size of the opening = 5 mm
Speed 2, cut nozzle - size of the opening = 6 mm
Speed 3, cut nozzle - size of the opening = 8 mm
Speed 4, cut nozzle - size of the opening = 8,5 mm
Speed 5, cut nozzle - size of the opening = 9 mm
Speed 6, cut nozzle - size of the opening = 9,5 mm
WARNING: Always observe the safety instructions and applicable
regulations.
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or
removing/installing attachments or accessories. An accidental start-up can
cause injury.
8.1 Running the Caulking Gun
Always check the flammability warnings on any product before attempting
to use
Proper hand position requires one hand on the main handle.
To start the unit, press the plunger rod release trigger (5) to pull the plunger rod handle back
(4),and then the plunger rod handle can be pulled out.
8.2 Variable Speed Dial
WARNING: Always switch off the tool when work is finished and before
removing the battery.
The adhesive’s rate of flow is controlled by the variable speed (6) to accomodate various
applications.
