POWDP2560 EN
Copyright © 2021 VARO P a g e | 9 www.varo.com
9.2 Removal / insertion of battery
WARNING: Before making any adjustments ensure the tool is switched off or
remove the battery pack.
▪ Hold the tool with one hand and the battery pack (9) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
9.3 Battery capacity indicator
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button. Before using the machine, please press switch trigger to
check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
▪ 3 LED’s are litt: Battery fully charged
▪ 2 LED’s are litt: Battery 60% charged
▪ 1 LED is litt: Battery almost discharged
10 ASSEMBLY
Disconnect the power plug before carrying out any adjustments or
maintenance.
Do not operate this mitre saw until it has been fully assembled and correctly prepared for use
in accordance with this instruction manual.
10.1 Assembling the side support bars
▪ Place the two guide rails into the side supports and secure them.
▪ Loosen the screw and place the side support bars into the positioning holes.
▪ Secure the side support bars with the screw to prevent them sliding out of position.
10.2 Assembling the clamp
The clamp (11) can be installed on either left or right side of the guide fence. Insert the vise
rod into the hole in the guide fence and fasten with locking screw
11 OPERATING INSTRUCTIONS
11.1 Transporting the mitre saw
To transport the power tool, use the retaining pin (17).
Pull the mitre saw downwards and lock it in the lowered position by pulling the retaining pin
and turn a quarter turn until the retaining pin engages. That way, the saw is secured.
11.2 Dust and chip extraction
For integrated dust extraction, place the dust bag (18) on the sawdust outlet.
For external dust, you can use a vacuum cleaner hose.
The dust bag is only for a partial dust removal! It is designed to break the
dust extraction.
