POWDP20160 EN
Copyright © 2020 VARO P a g e | 9 www.varo.com
9.2 Battery capacity indicator (Fig. 1a)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (9). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged.
2 LED’s are litt: Battery 60% charged.
1 LED is litt: Battery almost discharged.
9.3 Inserting and removing the battery (Fig. 2)
WARNING: Before making any adjustments ensure the drill is switched off
with the direction of rotation selector in the centre position.
▪ Hold the tool with one hand and the battery pack (5) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
9.4 Belt clip (Fig. 3)
▪ The belt clip (8) is convenient for temporarily hanging the tool.
WARNING: To reduce the risk of serious personal injury, turn off the tool
and disconnect the battery pack before making any adjustments or
removing/installing attachments or accessories.
WARNING: To reduce the risk of serious personal injury, DO NOT suspend
the tool overhead or suspend objects from the belt hook. Only hang the
tool’s belt clip on a proper work belt
WARNING: To reduce the risk of serious personal injury, ensure the screw
holding the belt hook is secure.
▪ When attaching or replacing the belt clip (8), use only the screw that is provided. Be sure
to securely tighten the screw. The belt clip can be attached to either side of the tool using
only the screw provided, to accommodate left- or right- handed users. If the belt clip is not
desired at all, it can be removed from the tool.
▪ To move belt hook or belt clip, remove the screw that holds it in place then reassemble on
the opposite side. Be sure to securely tighten the screw.
9.5 Selecting correct socket
Always use the correct size socket for bolts and nuts. An incorrect size socket will result in
inaccurate and inconsistent fastening torque and /or damage to the bolt or nut. Refer to
accessories section for socket size.
9.6 Installing or removing socket (Fig. 4)
▪ Always be sure that the tool is switched off and the battery pack is removed before
installing or removing the socket.
▪ To install the socket, push it onto the anvil of the tool until it locks into place. To remove
the socket, simply pull it off.
